Console House 10 Mode Provozní pokyny stáhnout pdf (Strana 97)

If Remote Commands Ok is set to No, then lights, appliances, and the

security system cannot be controlled from a remote telephone that dials

into your home.

You can issue commands from a local (in-house) phone with Remote

Commands Ok set to Yes or No.

If the system dials out, the called party can issue commands with

Remote Commands Ok set to Yes or No.

To set Remote Commands Ok to No, press 0 then ' # '. To change it

back to Yes, press 1 then ' # '.

The default for Remote Commands Ok is Yes.

Your phone must ring this number of times before the Omni will

answer an incoming call to your phone - See Answering Machines if

you have one.

To change Rings Before Answer, enter the new number from 1 to 15,

then press the ' # ' key.

The factory default for Rings Before Answer is 8.

The Dial Type specifies the type of dialing used when the Omni dials

out. If you do not have Touch Tone service, then Dial Type must be

set to Pulse.

To change the Dial Type to Pulse, press 1 then ' # '. To change the

Dial Type to Tone, press 0 then ' # '.

The default dial type is Tone.

My Phone Number is the phone number that will be announced when

the Omni dials out in the event of an alarm. It should be set to the

phone number of the premises where your system is installed.

Rings Before Answer

Dial Type

My Phone Number

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 135 136

Žádné komentáře

Console House 10 Mode Provozní pokyny Strana 97